sony KV20TS20 Repair Tips
Search: KV20TS20 sony
Results 8
Results 8
| Make | Model Ch. | Symptom | Problem Solution | Solution | By: |
|---|---|---|---|---|---|
| Sony | KV20TS20 | Snowy or intermittent picture, makes popping sound | Solder all coils in stand up board and tuner | ||
| Sony | KV20TS20 | TELEMATIC JIG SETUP, JIG SETTING HOR & VERT. | Published settings will not work. | ||
| Sony | KV20TS20 | NO AUDIO IN TV MODE, REPLACE SW Q-1444 ON "U" BOARD | Audio signal was present at pin 11 but not at pin 10 of audioselect IC-1406 (U-Board). | ||
| Sony | KV20TS20 | LINES ACROSS SCREEN, LEAKY C-535 | Lines across screen in lower half of picture. On screen dis-play of channel number showed in bottom right corner of picture as well asupper right corner. | ||
| Sony | KV20TS20 | INTERMITTENT PICTURE DISTORTION, OPEN C-501 | Intermittent picture distortion - Christmas tree effect. | ||
| Sony | KV20TS20 | SEVERE PIE CRUST EFFECT, OPEN C-501 | Unit exhibits severe pie crusting. Scope pin 11 showingdistorted in horizontal drive output. Indicating a bad IC-301. Thenreplaced IC-301 problem still exists. Did a component by component checkfor open capacitor in horizontal oscillator drive sectio | ||
| Sony | KV20TS20 | ANTENNA, SEE FLASH 43, 1-501-372-41 | Is the antenna supplied with the set or not? Also the AN-18Eis too big to fit into the hole in the back of the set. | ||
| Sony | KV20TS20 | HAM RADIO INTERFERENCE, TROUBLESHOOTING | Ham radio using 28-21-14-7-3 Mhz. When transmitting 100 wattsno problem, increasing between 400-1500 watts causes the audio to distortfrom his KV20TS20. The older KV-1712D is not affected. Installed 2 ferr-ite rods 7 inches long each on AC line & 2 Hi |